EMIT - Support Center

advanced search

Support center

Knowledge base

Support links

Home

Tools

Tag: Footplate

8 Articles

Why does the SmartLog Pro SE display “Check wrist cord connection”?

1309 views

If your wrist strap cord is not plugged in or is plugged in incorrectly, this message will appear. Please check your connection and try your test again. If you are doing footwear tests, please make sure the foot plate cable is securely connected on both ends. A loose cable can also cause this er...

Posted in: Hardware, SmartLog Pro SE

Can the footplate from previous SmartLog versions be used with the new SmartLog Pro®?

2742 views

No. The SmartLog Pro® uses a mini din-6 cable appose to previous models which use either a RJ11 jack or 3.5mm stereo jack....

Posted in: Hardware, SmartLog V5, SmartLog Pro

What are the test limits of the wrist straps and footwear on the SmartLog Pro®?

2176 views

For more information regarding test limits see the TB-6594 - SmartLog Pro® Installation, Operation and Maintenance Guide....

Posted in: Hardware, SmartLog Pro

What can you do if the SmartLog Pro® shows NO TEST for footwear testing for all employees no matter what test limit settings are in use?

3900 views

Reboot the SmartLog Pro® by power cycling it. Check that the SmartLog Pro® is properly grounded and make sure the foot plate cable is connected properly on both ends. Check the version number of the footplate in tester’s Admin menu. If the field is blank or shows 000, then the foot...

Posted in: Hardware, SmartLog Pro

When testing footwear, why do I receive “Error 3” on the screen?

1003 views

This would indicate a disconnect between the footplate and SmartLog Pro®. Please use the procedure below for resolving this issue: Turn the SmartLog Pro® off (disconnect power) Remove the footplate cable from the dual-footplate Inspect the pins of the footplate cable and make sure they...

Posted in: Hardware, SmartLog Pro

When testing footwear, why does it “timeout” even though I am on the footplate and pressing the switch?

964 views

This would indicate a disconnect between the footplate and SmartLog Pro®. This is a result of a loose or damaged footplate cable, footplate, SmartLog Pro or Ground. Please use the procedure below for resolving this issue. Footplate Cable and/or Footplate Troubleshooting: Turn the SmartLog P...

Posted in: Hardware, SmartLog Pro

What cleaning solution may be used to clean the footplate on a SmartLog?

2466 views

99% Isopropyl alcohol is the best choice for cleaning because it leaves little to no residue....

Posted in: Hardware, SmartLog V5, SmartLog Pro, SmartLog Pro SE, SmartLog Pro 2

How do you enable the footplate on the SmartLog Pro® if you have disabled it?

1941 views

To enable the footplate you first need to connect the footplate to the SmartLog Pro®. Once connected, go to the Admin menu on the SmartLog Pro by pressing “0” and Enter. If you are asked for an ID and Password it is also “0”. Once in the menu select “Foot Plate ...

Posted in: Hardware, SmartLog Pro

Page: 1 of 1