How do you enable the relay on the SmartLog Pro®?
Article ID: 88535

Question

How do you enable the relay on the SmartLog Pro®?

Answer

The relay terminal is located on the back of the SmartLog Pro®. Instructions for configuring it are described on page 8 of the SmartLog Pro® manual TB-6594, which is available for download here:

http://documents.descoemit.com/pdf/TB-6594.pdf

To enable the relay time in the TEAM5 software, this can be done at the Test Machine tab as shown in the image. You will only need the relay active for 1 second. You may adjust this in the relay time section of the SmartLog profile.

 

 

related articles

Will the SmartLog V5 log test results without the TEAM5 software?
Why doesn’t the SmartLog V5 power up?
Is TEAM5 compatible with both the SmartLog Pro® and SmartLog V5?
How often does the TEAM5 software collect ESD transactions from each SmartLog?
What should the Poll Frequency be set to when using a SmartLog Pro® in TEAM5?
Can multiple supervisors have access to the TEAM5 Enterprise software at one time?
How many operators can be the SmarLog Pro® handle before you see its performance decrease?
How many ESD tests can be stored on the SmartLog Pro®?
Can the ESD transactions stored on the SmartLog Pro® be extracted without the use of the TEAM5 software?
Can the ESD transactions stored on the SmartLog Pro® be viewed without the use of the TEAM5 software?

Article Details

Views: 2267	Created on: Feb 16, 2017 Date updated: Sep 02, 2020
Posted in: Software, TEAM5, TEAM5 Enterprise, Hardware, SmartLog Pro Tagged: TEAM5 Software, TEAM5 Enterprise, SmartLog Pro, Relay, Relay Time

Poor 1 2 3 4 5 Outstanding