EMIT - Support Center - SmartLog Pro 2

advanced search

Support center

Knowledge base

Support links

Home

Tools

Category: SmartLog Pro 2

9 Articles

What cleaning solution may be used to clean the footplate on a SmartLog?

2830 views

99% Isopropyl alcohol is the best choice for cleaning because it leaves little to no residue....

Posted in: Hardware, SmartLog V5, SmartLog Pro, SmartLog Pro SE, SmartLog Pro 2

Is the SmartLog Pro Manager Web Software compatible with SmartLogs older than the SmartLog Pro® SE?

604 views

SmartLog Pro® Manager is only compatible with the SmartLog Pro® SE and SmartLog Pro® 2 models. SmartLog Pro® models may be converted into SmartLog Pro® SE models with the purchase of a new SD card that has the correct programming. Please contact the EMIT Factory for more details....

Posted in: Software, Hardware, SmartLog Pro Manager Web, SmartLog Pro SE, SmartLog Pro 2

Can the SmartLog Pro® 2 be connected to an external monitor?

632 views

Yes. It has a VGA Port that outputs a mirrored image of the tester’s display to an external monitor. The native video resolution is 800 x 480....

Posted in: Hardware, SmartLog Pro 2

How many ESD tests can be stored on the SmartLog Pro® 2?

797 views

The SmartLog Pro®2 will store thousands of transactions before exceeding its memory. The SmartLog Pro® 2 is intended to be used with the SmartLog Pro Manager Web Software which continuously receives all transactions made at the tester, thus freeing up any memory being used. Internal flash memory al...

Posted in: General, Hardware, SmartLog Pro 2

When do I need to recalibrate the SmartLog Pro® 2 and how can I do it?

851 views

Frequency of re-calibration should be based on the critical nature of those ESD sensitive items handled and the risk of failure for the ESD protective equipment and materials. In general, EMIT recommends that calibration be performed annually. Use the EMIT 50424 Limit Comparator and EMIT 50784 5...

Posted in: General, Hardware, SmartLog Pro 2

Does the SmartLog Pro®2 have Wi-Fi capabilities?

889 views

Yes. Use the Wi-Fi setup to wirelessly connect the SmartLog Pro® 2 to the network in instances where a direct Ethernet cable is not used....

Posted in: General, Hardware, SmartLog Pro 2

How do you configure the proximity reader on the SmartLog Pro®2?

423 views

The SmartLog Pro® 2 contains an rf IDEAS WAVE ID®Plus reader capable of reading virtually any proximity or contactless card type in the world. The dual-frequency reader has the ability to hold four user-defined ID card configurations. You may use the procedure in the video linked below to configure...

Posted in: Hardware, SmartLog Pro 2

How do you connect the SmartLog Pro®2 to an Alvarado EDC turnstile?

478 views

You may use the procedure in the video linked below: https://youtu.be/jUueTy9N29s https://youtu.be/jUueTy9N29sThis process is also covered in the TB-6611 - Turnstile for SmartLog Pro® Installation, Operation, and Maintenance guide at the link below: https://www.descoindustries.com/PDF/TB-6...

Posted in: Hardware, SmartLog Pro 2

What purpose does the Calibration Due field serve in the SmartLogs section of SmartLog Pro Manager Web Software?

5 views

Calibration Due is just a convenient information field so you may document when the SmartLog needs to be calibrated. It does not impact the software or tester behavior. In general, EMIT recommends that calibration be performed annually. Use the EMIT 50424 Limit Comparator and EMIT 50784 5-Pound Ele...

Posted in: Hardware, SmartLog Pro Manager Web, SmartLog Pro SE, SmartLog Pro 2

Page: 1 of 1