What can you do if you are receiving test results for wrist straps at the SmartLog Pro® when you do not have a wrist strap plugged in?
Article ID: 97451

Question

What can you do if you are receiving test results for wrist straps at the SmartLog Pro® when you do not have a wrist strap plugged in?

Answer

We recommend that you clean the single wire jack with a burst of compressed air so the tester does not cumulate debris inside the jack. 

During repairs for this reported problem it was discovered that debris accumulated in between the sensors of the single wire jack may cause the tester to falsely detect that a cord is connected and fail the operator that is only testing for footwear.

 

 

 

related articles

Will the SmartLog V5 log test results without the TEAM5 software?
Why doesn’t the SmartLog V5 power up?
How often does the TEAM5 software collect ESD transactions from each SmartLog?
What should the Poll Frequency be set to when using a SmartLog Pro® in TEAM5?
How many ESD tests can be stored on the SmartLog Pro®?
Can the ESD transactions stored on the SmartLog Pro® be extracted without the use of the TEAM5 software?
What are the USB Ports on the SmartLog Pro® for?
Do the humidity and temperature sensors need to be calibrated?
Can the footplate from previous SmartLog versions be used with the new SmartLog Pro®?
Why does the SmartLog Pro® not initiate the ESD test after placing my finger on the test switch?

Article Details

Views: 1385	Created on: Sep 20, 2018 Date updated: Sep 02, 2020
Posted in: Hardware, SmartLog Pro Tagged: SmartLog Pro, Cleaning, Single Wire Jack, Compressed Air

Poor 1 2 3 4 5 Outstanding